Level Transmitter, 26Ghz Pulse Radar, 4-20mA Hart, 2" NPT, 90' Range

Description

Level Transmitter, 26Ghz Pulse Radar, 4-20mA Hart, 2" NPT, 90' Range
Tek-Wave 4300C Free Space Radar Level Transmitter is a 26GHz high-frequency radar type level measuring instrument measuring up to 90 feet. This high-frequency radar transmitter is the best choice for measuring solids and low dielectric constant medium. Easy to install with a horn that fits in a 2” NPT. The antenna is furthered optimized as the new fast microprocessor can carry out signal analysis and processing at a higher rate. Therefore, Tek-Wave 4300C Free Space Radar Level Transmitter can be used for complex measurement conditions. The 4300C is not affected by foam, changes in water vapor, temperature or pressure. Its shorter wavelength provides good reflections on sloping surfaces. The small beam angle and the energy is concentrated, enhancing the echo ability and avoiding interference. Smaller measurement blind areas help to achieve good results for small tank measurement.
East to install as small size antenna.
Non-contact radar without wear and pollution.
Hardly affected by corrosion, foam and changes in water vapor including temperature and pressure in the atmosphere.
Influence is minimal during serious dust environment.
Shorter wavelength.
Better reflection when inclined solid surface.
Small Beam angle and energy concentrated.
Enhance the echo ability and avoid interference.
Smaller measurement blind area.
High signal-to-noise ratio.
Can achieve better performance even in the case of fluctuation.
High frequency is the best choice for measuring solid and low dielectric constant medium
Accuracy
±3mm
Measuring Range
90ft (30m)
Microwave Frequency
26GHz
Maximum Pressure
Max. 580psi (4Mpa)
Process Pressure
-14.50 to 580psi (0.1 to 4Mpa)
Operating Temperature
-40 to 212°F (-40 to 100°C)
Process Temperature
-40 to 300°F (-40 to 150°C)
Medium Temperature
-40 to 300°F (-40 to 150°C)
Shock Resistance
Mechanical vibration 32.80ft/s2 (10m/s2), (10 to 150) Hz
Process Connection
2" NPT
Electrical Connection
½” NPT (Two)
Terminal Block
18 to 22 AWG Wire
Protection Class
IP67
Output Signal
4 to 20mA with HART®,
Fault Signal
current output unchanged;
20.5ma; 22mA; 3.9mA
Integration time
0 to 50s adjustable
Power Supply
16 to 26VDC
Power Consumption
Max 22.5mA/1w
Permissive Ripple
– <100Hz Uss
– (100 to 100K) Hz Uss
Blind Area
Antenna end
Response Time
About 1 second (depending on parameter setting)
Display
LCD
Display Resolution
1mm
Approval
CE